Whether it's a combat crash or a rough landing, nothing
bounces back like a TuffWing. It's made of super strong EPP foam and
it's reinforced with five carbon fiber spars for all out hi-speed
flying.
- EPP foam wings, CoroPlast accessories, carbon fiber
spars, and light weight make the TuffWing nearly indestructible.
- Assembles in about 2 hours. Pre-painted, pre-hinged, servo holes
pre-cut, control rods pre-cut with Z bends, motor mount pre-drilled,
builds with CA.
- Long battery life - 12 minutes at wide open throttle, or 30
minute relaxed flight times with a 1000 mAh LiPo.
- 100 plus MPH right out of the bag. CAD designed and CNC cut parts
ensure a precision fit.
- High contrast paint scheme makes it easy to see your TuffWing and
distinguish its top from bottom.
- Illustrated manual and
complete hardware pack.
- Made in Texas, USA.
$49.95
Specifications
Wingspan: |
24" ( 61cm) |
Weight - Fully loaded: |
10 oz. (283 g) |
Material: |
EPP foam, carbon fiber tubes,
Coroplast, plywood |
Battery: |
2200 mAh, 3 cell, lithium polymer |
Motor: |
Turnigy 2826-2200KV |
ESC: |
At least 20 amp |
Servos: |
9 gram mini (HXT 900,
Hitec HS 55) |
Propeller: |
APC 6x4E |
Launch method: |
Hand launch |
Gallery
Five carbon fiber spars
slide into precision CNC cut holes aligning the wing halves
and ensuring the the plane is rigid.
|
Servos and control linkages are located on the top of the
wing, where they belong so you don't have to worry about
damaging them when landing.
|
Self aligning laser cut motor mount builds in minutes with CA.
Hole spacing measured diagonally at 32.5 mm and 21.5mm - fits most X-mount type motors.
|
Laser and CNC router cut parts kit.
|
Built in electronics bay
fits battery, speed
control, and receiver.
|
With its low parts count and high prefabrication, building a
TuffWing only takes a couple of hours.
|
|
|